Mocom Milldrop Specifications download pdf (Page 26)

5. FIRST START-UP

MAX LEVEL IN THE

INTERNAL/

EXTERNAL DRAIN

TANK

Emptying the internal

tank

Detaching the pipe

Emptying the external

tank (option)

When the water level in the internal or external drain tank reaches the MAX level, the LCD

display alternatively lights the MAX and MIN icons.

NOTE

N THIS CONDITION THE UNIT WILL GENERATE AN ALARM INDICATION (SEE

PPENDIX E -

ALARM) AS YOU ATTEMPT TO LAUNCH A STERILIZATION CYCLE.

In this case, empty the internal or external draining tank.

Referring to the figure, open the door and operate in the

following way:

1. Arrange an empty tank on the floor near the sterilizer and put

the free end of the supplied tube into the tank;

2. Connect the quick connector to the corresponding female

connector under the chamber entrance (marked

pushing until you hear a click;

3. Wait for the complete empty of the internal tank; then while

pinching the tube with your fingers, press the metal lever

located on the side of the connector and detach the quick

connector.

Remove the top cap from the external tank and empty into a sink the water exceeding the

signed level.

WARNING

DO NOT EMPTY THE TANK COMPLETELY, BUT KEEP A QUANTITY OF

WATER UP TO THE MARKED LEVEL. OTHERWISE THE WATER DRAINING

SOUND AND THE STEAM ESCAPE FROM THE VENT-HOLE WILL

INCREASE CONSIDERABLY.

Refer to chapter “CONNECTING AN EXTERNAL DRAINING TANK” for more details.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 101 102

No comments

Mocom Milldrop Specifications Page 26