Mocom Milldrop Specifications download pdf (Page 17)

4. INSTALLATION

GENERAL

INSTALLATION

PRECAUTIONS

Obey the following warnings for the correct operation of the device and/or to avoid risky

situations:

– Install the sterilizer on a flat surface; if necessary, adjust the leveling feet to compensate

for an irregular surface.

Make sure that the support surface is strong enough

to support the equipment weight

(about 60 kg);

– Leave adequate space for ventilation

(at least 10 cm on each side) all around the

sterilizer, especially in back.

If the device is built-in to a cabinet, be sure to respect the warnings in the preceding

paragraph, avoiding an obstructions to the air intake;

– Do not install the sterilizer near tubs, sinks or similar places, to avoid

contact with water or

liquids. This could cause short circuits and/or potentially dangerous situations for the

operator;

– Do not install the sterilizer in a place that is excessively humid or poorly ventilated;

– Do not install the machine were there is gas

or inflammable and/or explosive vapors;

– Install the device so that the power cord is not

bent or crushed. It must run freely all the

way to the socket.

– Install the device that any external fill/drain tubing is not

bent or crushed. They must run

freely to the drain tank.

ELECTRICAL

CONNECTIONS

The sterilizer's must be connected to a socket of the electrical system of adequate capacity for

the device's absorption and ground provided, in conformity with current laws and/or standards.

The socket must be suitably protected by a breaker having the following characteristics:

– Nominal current I

16 A

– Differential current I

Δn

0.03 A

WARNING

THE MANUFACTURER WILL NOT BE LIABLE FOR DAMAGES CAUSED BY

INSTALLING THE STERILIZER ON AN INADEQUATE ELECTRICAL

SYSTEM AND/OR NOT EQUIPPED WITH A GROUND.

If it is necessary to replace the plug on the power cord, use one with equal characteristics or,

at any rate, adequate to the device's electrical characteristics. The user is entirely responsible

for the selection and replacement of the plug.

NOTE

LWAYS CONNECT THE POWER CORD DIRECTLY TO THE SOCKET. DO NOT USE

EXTENSION CORDS

, ADAPTERS OR OTHER ACCESSORIES.

CONNECTION OF

USB PEN DRIVE

RECORDING

DEVICE

The recorded data can be copied, read and printed using Millflash software

installed on a compatible personal computer that is fitted with a USB port.

Installation of the Millflash software stored on the CD-rom and attached to the operating

documentation.

– Insert the cd-rom into the CD drive of the PC.

– Click on “setup_Millflash [rev]”.

– Follow the installation instructions that appear on the display. During

– installation, a "Millflash" folder is created which contains the

– necessary files.

In addition, a programme icon is created on the PC's desktop.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 101 102

Comments to this Manuals

No comments

Mocom Milldrop Specifications Page 17

Comments to this Manuals