Mocom Milldrop Specifications download pdf (Page 25)

5. FIRST START-UP

FILLING DISTILLED

WATER

Manual filling

Detaching the pipe

Automatic filling

The first time the sterilizer is used, and later when the MIN water level indicator comes on, you

will have to fill, or top-off, the internal distilled water tank.

With reference to the figure (and with the door open), proceed as follows:

1. Fill the manual container (2 l) with distilled water,

keeping it horizontal;

2. Connect the tube’s quick connector to the

corresponding female connector under the

chamber entrance (marked

), pushing until

you hear a click;

3. Place the container in a vertical position, at the

same time, loosening the plug and taking care

not to spill water on the machine.

4. The water will begin to flow into the tank;

5. Continue filling until the MIN level indicator turns

off.

6. Continue until the water is drained from the container;

7. At this point, lower the connector below

the connection point, keeping it horizontal;

8. While pinching the tube with your fingers, press the metal lever located on the side of the

connector and detach the quick connector;

9. Refill the container (2 l) and repeat the operations described in points 2, 3 and 4 a second

time;

10. When the MAX level

icon comes on (accompanied by a beep), stop filling and detach the

quick connector as described in points 7 and 8.

NOTE

HE ICON MAX DOES NOT HAVE TO BE ON TO START A STERILIZATION PROGRAM. THE

ICON

MIN INDICATOR OFF IS SUFFICIENT.

In the event of sterilzer installation for automatic filling from an external tank or demineralizer

Milldrop (see the Chapter, “Installation”), the filling will occur automatically after the automatic

filling option has been selected.

Obviously, for the correct operation, the user must fill the external tank or switch on the

Milldrop in advance.

NOTE

SE ONLY HIGH QUALITY DISTILLED WATER. FOR THE SPECIFICATIONS OF THE WATER

SUPPLY

, SEE APPENDIX A (TECHNICAL CHARACTERISTICS).

To set the automatic filling option, please refer to the Chapter, “Configuring the Device”.

WARNING

THE AUTOMATICALLY FILLING SYSTEM MUST NEVER RUN DRY; THIS

CAUSES PREMATURE WEAR TO THE AUXILIARY WATER-INJECTION

PUMP. PERIODICALLY CHECK THE WATER LEVEL IN THE EXTERNAL

TANK (OPTIONAL)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 101 102

Comments to this Manuals

No comments

Mocom Milldrop Specifications Page 25

Comments to this Manuals